WORKING ON THIS PAGE. Will be updated as I complete the project!

This fence was made out of wood pallets. I looked on Craig's List for any kind of wood I could find and found a local glass company that was giving away wood pallets for free, just had to pick them up.

I took them apart and measured out a base length and laid down 2 long pieces of wood the same length and took 3 smaller pieces (all close to the measurement of each other but not exact). Just using sheet rock screws I put 1 screw in each plank, One on top and one on bottom. At this point I only have 7 runs.

Here I have placed the planks where I want my walk way. I put 1 rebar rod (2' long) into the ground with about 6" still out of the ground. These were placed in the center of the planks and on both sides of the rod a 1" hole was drilled into the plank to put a zip tie through and around the rod. This is what hold the run in place and secures it to the ground.

At this point in time I need to build another 7 runs to complete the walkway to the road.

MORE TO COME, CHECK BACK SOON!